I am contemplating building a table for my medium egg. I have read lots on this forum, as well as other places, about plans, problems, materials, etc.
I know how important for fire safety having good air gaps around and under the egg are when putting it in a table.
One question I have not seen answered is how much of a gap between the table and the egg is needed for reasonable fire safety?
Too turn this question into a middle school algebra question:
I decide I want to have my egg sticking up a few inches above the table top.
I then then measure and determine that X is the diameter of the egg at the level that it will emerge from the table top.
What should the diameter of the hole in the table top be?
X+2" (a one inch gap all the way around) ?? X + 1"? X + .2"
Any ideas or suggestions?
I know how important for fire safety having good air gaps around and under the egg are when putting it in a table.
One question I have not seen answered is how much of a gap between the table and the egg is needed for reasonable fire safety?
Too turn this question into a middle school algebra question:
I decide I want to have my egg sticking up a few inches above the table top.
I then then measure and determine that X is the diameter of the egg at the level that it will emerge from the table top.
What should the diameter of the hole in the table top be?
X+2" (a one inch gap all the way around) ?? X + 1"? X + .2"
Any ideas or suggestions?