Hello everyone,
This will be my second build of the Naked Whiz plans. I am now building one as a wedding present for a friend. My table had ceramic feet, his does not so I am probably going to get the table nest. From my research the table nest adds 2"in height, vs ceramic feet add 0.75" in height. I would presume that if I used dimension X @ 17" for my previous build, I should reduce it by 1.25" (2"-0.75") for the new build with the table nest for an X dimension of 15.75". The only thread I could fine was this one
http://eggheadforum.com/discussion/1139835/yet-another-new-table-with-table-nest
The OP suggested using and X dimension of 16.5" but I can figure out why and his egg looks way too high in the table for my liking. Any thoughts? I cant use trial and error cause his egg is 60+ miles away and I have to drive the table there. Thanks in advance
Naked whiz plans for reference
http://www.nakedwhiz.com/cart.htm
Table nest for reference
http://biggreenegg.com/product/table-nest/
This will be my second build of the Naked Whiz plans. I am now building one as a wedding present for a friend. My table had ceramic feet, his does not so I am probably going to get the table nest. From my research the table nest adds 2"in height, vs ceramic feet add 0.75" in height. I would presume that if I used dimension X @ 17" for my previous build, I should reduce it by 1.25" (2"-0.75") for the new build with the table nest for an X dimension of 15.75". The only thread I could fine was this one
http://eggheadforum.com/discussion/1139835/yet-another-new-table-with-table-nest
The OP suggested using and X dimension of 16.5" but I can figure out why and his egg looks way too high in the table for my liking. Any thoughts? I cant use trial and error cause his egg is 60+ miles away and I have to drive the table there. Thanks in advance
Naked whiz plans for reference
http://www.nakedwhiz.com/cart.htm
Table nest for reference
http://biggreenegg.com/product/table-nest/