Greeting Eggers,
My table project is finally complete! It's a big heavy table (6ft X 3ft) with the hinge cutout. I'm a new Egger with not a lot of carpentry experience and ZERO BGE experience. I did a test light up and used the oil/paper towel method to start the lump (read it here and it worked perfectly - thanks). I kept a stable 300 for half an hour for practice, but noticed a small gap in the back - so I shut it down... I've got a band/alignment issue but will work on that tonight (band not tight in photos). Hope you like it - did lots of reading on this forum and wouldn't have made it far without this site so thank you!
![]( "Image: https://us.v-cdn.net/5017260/uploads/editor/2v/kvk3klebi3hz.jpg")
![]( "Image: https://us.v-cdn.net/5017260/uploads/editor/k8/qgbnw1v7gnsb.jpg")
![]( "Image: https://us.v-cdn.net/5017260/uploads/editor/48/4pjq283abovi.jpg")
![]()
![]( "Image: https://us.v-cdn.net/5017260/uploads/editor/c2/c9vfupoie9yu.jpg")
Now to cook something![:)]( ":)")
My table project is finally complete! It's a big heavy table (6ft X 3ft) with the hinge cutout. I'm a new Egger with not a lot of carpentry experience and ZERO BGE experience. I did a test light up and used the oil/paper towel method to start the lump (read it here and it worked perfectly - thanks). I kept a stable 300 for half an hour for practice, but noticed a small gap in the back - so I shut it down... I've got a band/alignment issue but will work on that tonight (band not tight in photos). Hope you like it - did lots of reading on this forum and wouldn't have made it far without this site so thank you!
Now to cook something
